Wireless user station WB-2P-LR5

• 802.11a/n/ac (5G Wi-Fi) 
• MIMO 2x2
• Power of the transmitter 24 dBm 
• Integrated antenna 12 dBi
• РoЕ injector 24V
• Reset button on the injector

Short description
Eltex presents a user station WB-2P-LR5 operating at 5 GHz. The device is dedicated for Point-to-Point or Point-to-Multipoint networks and performs well even in a challenging weather conditions. WB-2P-LR5 has a high-performance radio link with integrated antenna performing high gain and narrow pattern. The station is equipped with a 1G PoE port and a Wi-Fi chip supporting 802.11ac Wave 2 standard for reaching maximum bandwidth.

Due to the high performance of the WB-2P-LR5, Eltex guarantees a short pay-off period.

• WLAN: IEEE 802.11a/n/ac
• LAN: 1 Ethernet port RJ-45 10/100/1000BASE-T

• Support for IEEE 802.11a/n/ac standards
• Data aggregation, including A-MPDU (Tx/Rx) and А-MSDU (Rx)
• Priorities and packet planning based on WMM
• Automatic scanning of neighboring access point channels 
• Support for APSD

• Centralized authentication via RADIUS server (WPA/WPA2 Enterprise)
• WPA/WPA2 encryption
• 64/128/152-bit WEP encryption

• Frequency range 5180 - 5320, 5500 - 5825 MHz
• BPSK, QPSK, 16QAM, 64QAM, 256QAM modulations
• Bandwidth: 5, 10, 20, 40, 80 MHz

• 802.11ac: 867 Mbps

• 5 GHz: up to -94 dBm
  

• 5 GHz: 24 dBm

• Antenna gain: 12 dBi
• Linear polarization: H/V
• SWR: 2.0:1
• Beam width (H): 60°
• Beam width (V): 15°

• VLAN Trunk 
• Management VLAN
• General VLAN
• Static routing
• Time synchronization via NTP

• Firmware update and configuration via DHCP-autoprovisioning, TR-069
• Remote management via Telnet, SSH
• Web interface

• Power consumption up to 8 W
• Processor –  Realtek RTL8197FS 1 GHz
• RAM 128 MB
• Flash 32 MB
• Power supply: PoE 24 V
• Operation temperature: from -45°С to +65°С
• Operation humidity: up to 95%
• Dimensions (WхHхD): 80x66x282 mm
• IP54 protection
• Pole mounting

^¹The maximum wireless data rate is defined according to IEEE 802.11n/ac standard. The real bandwidth can be different. Conditions of the network, environment, the amount of traffic, building materials and constructions and network service data can decrease the real bandwidth. The environment can influence on the network coverage range.