You will receive on your e-mail all the news about the product, updating software and documentation!

Descriptions

wep_2ac_datasheet_1.12.2_en.pdf

Documentations

WEP-2ac_WEP-2ac Smart_user_manual_1.16.0 Quick manual

Software

Firmware version 1.8.0 Firmware version 1.12.2

Downloads

WEP-2ac

High-performance solution based on Broadcom chipset
802.11 ac (5GWi-Fi) support
PoE+, leased lines
Work in a cluster without a dedicated server (up to 64 devices)
Seamless roaming
Modern means of authentication and encryption

Solution for businesses

WEP-2ac provides high-speed, secure, affordable and easy-to-use wireless network that combines a variety of features and services needed for corporate clients. WEP-2ac will become a universal solution for setting up a wireless network with a large number of users and high traffic (office, government offices, conference rooms, laboratories, hotels, etc.).

Wireless

Due to IEEE 802.11ac standard support the access point WEP-2ac provides data rates of up to 650 Mbit/s. Four dual-band antennas and large radius coverage (up to 200m) make WEP-2ac a universal access point when organizing a corporate network.

Security

For the corporate environment there are modern authentication and encryption technologies, which provide protection of personal data and the security of the corporate environment. In an enterprise environment a dynamic key is used individually for each client working at the moment.

Power supply

Support for PoE+ allows installation in any location, regardless of the location of power supplies, saves on the cost of power cables, makes installation easy and quick. Power is supplied from the mains via power adapter or a separate power cable when using sequential circuit of connecting devices "point-to-point".

Interfaces

1 port Ethernet 10/100/1000 Base-T (RJ-45)
Console (RJ-45)

WLAN features

Supporting standards IEEE 802.11a/b/g/n/ac
Aggregation of data, including A-MPDU (Tx / Rx) and A-MSDU (Rx)
Priorities and packet scheduling based on WMM
Dynamic Frequency Selection (DFS)
Supports of hidden SSID
32 virtual access points
Finding a third-party access points
APSD
WDS

Networking features

Speed auto-coordination, duplex mode and switching between MDI and MDI-X
VLAN support
Support for 802.1X authentication
DHCP-Client
LLDP
ACL
Support for IPv6

Operation in a cluster mode

Organization of the cluster with up to 64 access points
Load balancing between access points
Automatic synchronization of configurations of access points in the cluster
Single Management IP - a single address to control access points in the cluster
Automatic allocation of frequency channels between APs
Authentication via RADIUS-server

QoS features

The priority and scheduling of packets on the basis of profiles
Limiting bandwidth for each SSID
Changing the WMM parameters for each radio interface

Security

Centralized authentication via RADIUS-server (WPA Enterprise)
WPA / WPA2 encryption
Captive Portal support
E-mail notifications about system events

The parameters of the wireless interface

Frequency range 2400 - 2483.5 MHz, 4900 - 5850 MHz
Modulation CCK, BPSK, QPSK, 16QAM, 64QAM, 256QAM
Internal omnidirectional antenna
Support for 2x2 MIMO
The two integrated Broadcom BCM47452 chip (5 GHz, IEEE 802.11a/n/ac) and BCM43217 (2.4 GHz, IEEE 802.11 b/g/n)
Operating Channels

- 802.11b/g/n: 1-13 (2412-2472 MHz)
- 802.11 a/n/ac:
- 36-64 (5180 - 5320 MHz)
- 100-144 (5500 - 5720 MHz)
- 149-165 (5745 - 5825 MHz)

The data rate, Mbit/s

Receiver sensitivity

dBm

Maximum transmitter power

dBm

Physical characteristics

Broadcom BCM47452 processor
128 MB NAND Flash
256 MB of RAM DDR3
Power: PoE + 48V / 54V (IEEE 802.3at-2009)
Operating temperature 0 ° C to + 60 ° C

Configuring

Software update and configuration via DHCP Autoprovisioning
Remote management for Telnet, SSH
Web-based interface
SNMP